power

The process of measuring the frequency of a signal.

The process of measuring the demodulated frequency rate of an Amplitude Modulate (AM) signal.

This process measures the Deviation Frequency of a Frequency Modulated (FM) signal. The deviation is used to describe the maximum difference between an FM modulated frequency and the nominal carrier frequency

The process of measuring the Demodulated Rate of a Frequency Modulated (FM) Signal.

The process of measuring the demodulated frequency rate of a phase-modulated RF signal.

A test process of measuring power spectral density offset from the carrier as compared to the carried power.

The process of measuring the phase-modulated component of a phase-modulated RF signal typically in radians.

The process of measuring the Reflection Coefficient Phase of an RF signal that is reflected back to the transmitting port.

The process of measuring the Transmission Coefficient Phase of an RF signal that transmitted through the device under test.

A test process that measures the RF power of a signal. It can be either direct or monitored by an RF Power measurement device

The time-average ultrasonic power emitted by an ultrasonic transducer. The measurement of ultrasonic power in liquid is based on the measurement of radition force using a gravimetric balance. The acoustic power radiated from the transducer can be related to the radiation force measured by an electronic balance.

The process of measuring the Percent of Modulation of an Amplitude Modulation (AM) Signal.

The process of measuring the Reflection Coefficient magnitude of an RF signal that is reflected back to the transmitting port.

A test process that measures the difference between 2 sinusoidal RF signals at different frequencies while keeping the power levels constant. The two measured values are compared, the results can be expressed as dB or percent of change. These two signals are often used when calibrating flatness of a signal generator or similar device.

A test process that measures the difference 2 sinusoidal RF signals at different power levels keeping the frequency constant. The two measured values are compared, the results can be expressed as Delta dB or percent of change. These two signals are often used when calibrating the linearity of a device.

The process of measuring the Transmission Coefficient magnitude of an RF signal that transmitted through the device under test. It is represented as a ratio of power received over the transmitted power.

The process of generating a frequency-stable RF Sinewave waveform.

The process of sourcing a sinusoidal AC Power signal from a device and measuring the value on the UUT. This test process can be used by any device that measures absolute AC power.

The process of sourcing a sinusoidal AC Power signal from a device where the Volts and Amps are provided on two different outputs and measured by the UUT as Watts / Power. This test process can be used by any device that measures AC power with separate voltage and current inputs.

The process of sourcing DC Power signal from a device and measuring the value on the UUT. This test process can be used by any device that measures absolute DC power.

The process of sourcing a sinusoidal DC Power signal from a device where the Volts and Amps are provided on two different outputs and measured by the UUT as Watts / Power. This test process can be used by any device that measures AC power with separate voltage and current inputs.

This process connects a Termination to the input of a measurement device to reduce the noise and outside electrical signals. The test process is typically used to measure the UUT’s internal noise and offsets. And can be expressed in watts or dBm.

A test process the sources 2 sinusoidal RF signals at different frequencies keeping the power levels constant between the two frequencies. The FrequencyRef signal is sourced and the voltage is measured by the UUT and saved as the Reference value. Then the signal is changed to the test Frequency signal and the test value is measured on the UUT. The two measured values are compared, the results can be expressed as dB or percent of change. These two sinusoidal signals are often used when calibrating bandwidth or frequency response on an Oscilloscope or similar device.